Wear experiments on PLA-Cu composite filament printed in different FDM conditions
Main Article Content
Abstract
The fabricated 3D composite filaments are processed and evaluated for wear property using the pin on disc technique in a Fused Deposition Model (FDM). When measurements are taken under various machining conditions such as load, track diameter, and speed, Grey Relational Analysis (GRA) is used to optimize friction strength and wear rate. Some relevant similarities of those other metrics are found and documented using Analysis of Variance (ANOVA). It is notable that the applied test load appears to have a greater contribution of about 76 percent and appears to have a high effect on the sample's end quality. To check the findings, a validation experiment is also carried out.
Downloads
Metrics
Article Details
You are free to:
- Share — copy and redistribute the material in any medium or format for any purpose, even commercially.
- Adapt — remix, transform, and build upon the material for any purpose, even commercially.
- The licensor cannot revoke these freedoms as long as you follow the license terms.
Under the following terms:
- Attribution — You must give appropriate credit , provide a link to the license, and indicate if changes were made . You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.
- No additional restrictions — You may not apply legal terms or technological measures that legally restrict others from doing anything the license permits.
Notices:
You do not have to comply with the license for elements of the material in the public domain or where your use is permitted by an applicable exception or limitation .
No warranties are given. The license may not give you all of the permissions necessary for your intended use. For example, other rights such as publicity, privacy, or moral rights may limit how you use the material.